Atacama Audition 500 Speaker Stands (Pair)

Description

The Audition Series Speaker stands have a large 360mm by 225mm laser cut top plate and can be used with either dimension being front facing. This allows both large, wide but shallow speakers to be supported as well as the more numerous deep cabinet types.

The Audition Series are supplied in a Satin Black paint finish Diamond White as a cost option.

Each pair of Audition stands are equipped with new 5mm thick laser cut carbon steel base plates, eight heavy duty BZP 8mm adjustable floor spikes featuring stainless steel detailed top caps and upgraded High Load Trapezoidal (HLT) Isolation Gel Pads for the top plates.

We recommend that each pair are mass loaded with Atabites in order to maximize their sonic potential (see below for quantity guidance and recommendations on the amount of mass filler to use).

Floor spikes and HLT Isolation Gel pads are included with each pair of stands, with the option of adding Atabite mass loading filler, top spikes and spike shoes if required.

As these speaker stands use isolation spikes, two sets of four Atacama HD-L (Nickel finish) spike shoes are recommended to protect delicate floor coverings.

Single stands can be supplied if required; please contact your local Atacama stockist or the Atacama sales department on 01455 283251 for pricing and availability (UK only).

Audition speaker stands are designed and manufactured in the UK.

These are a specialist speaker stand, so are made to order. Allow 2-3 week manufacturing times.

Dimensions: -

Overall Height (Including HLT Gel Pads and Floor Spikes)

Audition 300      335mm   (13.19”)
Audition 400      435mm   (17.12”)
Audition 500      535mm   (21.06”)
Audition 600      635mm   (25”)
Audition 700      735mm   (28.9")

Top Plate Dimensions

Setup 1. Width 360mm (14.17”), Depth 225mm (8.9”)
Setup 2. Width 225mm (8.9”), Depth 360mm (14.17”)

Base Plate Dimensions

Setup 1. Width 400mm (15.7”), Depth 305mm (12”)
Setup 2. Width 305mm (12”), Depth 400mm (15.7”)

Weight Capacity 20KG per stand.

Note- Supported speaker width/depth dimensions should not exceed speaker stand base plate dimensions.

 Atabite quantity recommendation

Below are stated the recommended number of tubes to share between each pair of speaker stands. All vertical poles should be equally filled. Amounts are approximate and will not necessarily completely fill the tubes. It is suggested that you experiment with the exact amount to achieve the best sonic results for your particular system setup as the speakers, room acoustics, cable loom, positioning of the speakers and hifi components will determine how much Atabite filler to use to get the best sound from your speakers.

As a general rule, approximately half to two thirds full gives the best results. If you find the speakers are lacking high end detail and sounding dull at the lower end that usually means you have overfilled the stands and will need to reduce the volume of Atabites in each stand.

 If the speakers are new, it is suggested that the exact amount of Atabites needed will best be determined once they are run in. Refer to your speaker instructions or contact the supplying retailer/ manufacturer for guidelines on running in recommendations. 

Audition 300     2 Tubs       
Audition 400     3 Tubs
Audition 500     4 Tubs
Audition 600     5 Tubs
Audition 700     6 Tubs